delorie.com/archives/browse.cgi   search  
Mail Archives: geda-user/2012/05/24/14:45:02

X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient: geda-user AT delorie DOT com
Message-ID: <4FBE8123.2090205@laserlinc.com>
Date: Thu, 24 May 2012 14:42:43 -0400
From: Joshua Lansford <Joshua DOT Lansford AT laserlinc DOT com>
User-Agent: Mozilla/5.0 (X11; Linux i686; rv:12.0) Gecko/20120428 Thunderbird/12.0.1
MIME-Version: 1.0
To: geda-user AT delorie DOT com
Subject: Re: [geda-user] Chassis ground vs Circuit ground
References: <4FBE499D DOT 2090509 AT laserlinc DOT com> <CAN0Jx-9co9=9cU9aGfKdyhmjQC3je+n-3z0vFM+4xYDiCGvcoQ AT mail DOT gmail DOT com>
In-Reply-To: <CAN0Jx-9co9=9cU9aGfKdyhmjQC3je+n-3z0vFM+4xYDiCGvcoQ@mail.gmail.com>
Reply-To: geda-user AT delorie DOT com

Sounds like the edges shouldn't be plated as they would form new 
"drawbridges" in addition to the power supply header.
(http://www.sigcon.com/Pubs/news/7_02.htm)
The second link suggests the edges be grounded to shunt current.  But 
this is only recommended if the inputs must reference chassis ground 
which mine are not.
(http://www.sigcon.com/Pubs/edn/multipleadc.htm)

But without sensitive analog signals to protect besides the Ethernet 
signal I am probably good any which way I go.  I am just trying to learn 
best practice.

Thank you Russell.
That was informative.
~Joshua

On 05/24/2012 11:26 AM, Russell Dill wrote:
> On Thu, May 24, 2012 at 7:45 AM, Joshua Lansford
> <Joshua DOT Lansford AT laserlinc DOT com>  wrote:
>> Hello.
>>    I have an Ethernet Jack with a separate chassis ground.  The grounds
>> connect by zero ohm resistors beside the jack.  Supposedly this keeps noise
>> from following the cable onto board.  I saw somewhere not connect chassis
>> and  together on the board but though the enclosure.  The card with plated
>> edges slides into a metal extrusion.  Should both edges be chassis ground or
>> should one be circuit ground?   This supposedly keeps a DC difference from
>> developing but dissipates noise.  What are your opinions about how to deal
>> with chassis ground vs circuit ground?
>> ~Joshua
> http://www.sigcon.com/Pubs/news/7_02.htm
> http://www.sigcon.com/Pubs/edn/multipleadc.htm
> http://www.sigcon.com/Pubs/news/2_17.htm
>
>

- Raw text -


  webmaster     delorie software   privacy  
  Copyright © 2019   by DJ Delorie     Updated Jul 2019