X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
X-Mailer:	exmh version 2.8.0 04/21/2012 with nmh-1.7+dev
X-Exmh-Isig-CompType:	repl
X-Exmh-Isig-Folder:	inbox
From:	"karl AT aspodata DOT se [via geda-user AT delorie DOT com]" <geda-user AT delorie DOT com>
To:	geda-user AT delorie DOT com
cc:	karl AT aspodata DOT se
Subject:	Re: [geda-user] PCB connect pad to plane
In-reply-to:	<CAHUm0tM8SA65tcRugq6zVmdFrbw2OStz=3YN2mNPn8RUCTX=KA@mail.gmail.com>
References:	<CAGBFkM2Bja4mjn-7mt_WUcw5AHa6DLJgrZdCDp5cpauGmy6UuA AT mail DOT gmail DOT com> <CAHUm0tM8SA65tcRugq6zVmdFrbw2OStz=3YN2mNPn8RUCTX=KA AT mail DOT gmail DOT com>
Comments:	In-reply-to "Erich Heinzle (a1039181 AT gmail DOT com) [via geda-user AT delorie DOT com]" <geda-user AT delorie DOT com>
	message dated "Sat, 03 Oct 2020 23:11:49 +0930."
Mime-Version:	1.0
Message-Id:	<20201003151644.BF3F482AE539@turkos.aspodata.se>
Date:	Sat, 3 Oct 2020 17:16:44 +0200 (CEST)
X-Virus-Scanned:	ClamAV using ClamSMTP
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

Erich:
> the thermal tool can be a bit counter intuitive
> 
> if you select the layer of copper it needs to connect to in the layer
> list, _then_ apply the thermal tool, you can cycle through thermal
> types to connect the pad to this layer.
...

The thermal tool don't work on pads in pcb, only pins.

Regards,
/Karl Hammar

- Raw text -