X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] pcb slotted holes for relay
To:	geda-user AT delorie DOT com
References:	<CALSZ9greJFrL=dBWNUo3NS68Jq=B=C7nLO4FDB+vowa2B1DjwQ AT mail DOT gmail DOT com>
	<15585a1f-79e3-3aa2-3f9e-239365b53bed AT ecosensory DOT com>
	<CALSZ9gqJkoHXW8SazY_7S3k66tapTgMbFgmqCE=uWqf_yfR4cw AT mail DOT gmail DOT com>
From:	"John Griessen (john AT ecosensory DOT com) [via geda-user AT delorie DOT com]" <geda-user AT delorie DOT com>
Message-ID:	<31796c90-47a3-2dc9-a6a1-a5dec320a2a3@ecosensory.com>
Date:	Sat, 12 Aug 2017 15:58:37 -0500
User-Agent:	Mozilla/5.0 (X11; Linux x86_64; rv:45.0) Gecko/20100101
	Thunderbird/45.8.0
MIME-Version:	1.0
In-Reply-To:	<CALSZ9gqJkoHXW8SazY_7S3k66tapTgMbFgmqCE=uWqf_yfR4cw@mail.gmail.com>
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

On 08/12/2017 01:05 PM, Rob Butts (r DOT butts2 AT gmail DOT com) [via geda-user AT delorie DOT com] wrote:
> How do I "put it" in the outline layer?

that is handled informally, so you can say the centerline of the outline trace is to be the edge to router
cut to, or have it be the outside edge of the trace, your preference.

To me, the centerline makes sense, and I draw it with a fine trace and I don't expect super precision,
so it's going to be about right.  So then you draw arcs and lines to define your outline and draw places inside it
to define cutouts.

If you are doing ten of them, you could wait until pcb-rnd has the feature and use it if the effort of a
new install is not so much of a cost.  I am compiling it frequently and can give you a howto of it.

Then you could put the slots in a footprint like we all have wanted since forever.

- Raw text -