X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
X-Mailer:	exmh version 2.8.0 04/21/2012 (debian 1:2.8.0~rc1-2) with nmh-1.5
X-Exmh-Isig-CompType:	comp
X-Exmh-Isig-Folder:	inbox
From:	karl AT aspodata DOT se
To:	geda-user AT delorie DOT com
Subject:	[geda-user] Education board
Mime-Version:	1.0
Message-Id:	<20170812171643.704388072A28@turkos.aspodata.se>
Date:	Sat, 12 Aug 2017 19:16:43 +0200 (CEST)
X-Virus-Scanned:	ClamAV using ClamSMTP
Reply-To:	geda-user AT delorie DOT com

I'm contenplating to make a board design suitable for embedded 
programming courses, so if anyone is interested you are welcome to
make suggestions.

My spec would be something like:
 suitable to be done by yourself
  public design/open hw
  2-layer pcb
  not too small components, parhaps >= 1608 metric (0603)
  throught hole components to ease routing
  use common values, e.g. E6-series
  one pcb instead a few connected
 has
  serial port
  can-bus
  i2c
  spi
  dac
  adc
  usb (device only?)
  h-bridge for motor control ?
  ethernet ?
  onboard switches
  leds
  irda ?
  rs485 ?
  fram
  eeprom
  ntc-inputs
  pt100-inputs
  chip reader (as in credit card with chip)?
  micro sd car
  1-wire bus + DS18B20 temp.sensor ?

Regards,
/Karl Hammar

-----------------------------------------------------------------------
Aspö Data
Lilla Aspö 148
S-742 94 Östhammar
Sweden
+46 173 140 57

- Raw text -