X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] handsolder QFN packages
To:	geda-user AT delorie DOT com
References:	<20170322172551 DOT DF40C8106DD0 AT turkos DOT aspodata DOT se>
	<201703221400 DOT 51991 DOT gheskett AT shentel DOT net>
	<20170322210114 DOT 08D208106DD0 AT turkos DOT aspodata DOT se>
	<CAHUm0tOOZm8RoJgi37PyObp71bJtxEJ3=dWFwVWvgNUyJDNcdg AT mail DOT gmail DOT com>
From:	"John Griessen (john AT ecosensory DOT com) [via geda-user AT delorie DOT com]" <geda-user AT delorie DOT com>
Message-ID:	<dbe8fe6e-7cbb-680f-fff1-ab8057ff5c50@ecosensory.com>
Date:	Wed, 22 Mar 2017 21:41:48 -0600
User-Agent:	Mozilla/5.0 (X11; Linux x86_64; rv:45.0) Gecko/20100101
	Thunderbird/45.8.0
MIME-Version:	1.0
In-Reply-To:	<CAHUm0tOOZm8RoJgi37PyObp71bJtxEJ3=dWFwVWvgNUyJDNcdg@mail.gmail.com>
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

On 03/22/2017 04:15 PM, Erich Heinzle (a1039181 AT gmail DOT com) [via geda-user AT delorie DOT com] wrote:
> The key features are a ~3mm thick plate to spread the heat, having the
> 800W hot plate starting at ambient remain on for 250 seconds, then
> turned off, then lifting off the board with the jig at about 280
> seconds, to get a really good fit to the recommended JEDEC heating
> curve.
>
> http://vk5hse.blogspot.com/2011/05/finishing-off-sdr-cube-transceiver.html
>
> being able to lift the board without jostling at 280 seconds avoids
> the problem of thermal inertia of the hot plate continuing to heat the
> board longer than necessary.


Thanks, I'm going to try this with my hotplates too.  Not sure which one will give the best thermal
rise-time, so I'll try both.  Do you know your hotplate wattage and mass?  One of mine is cast iron top,
one aluminum.

- Raw text -