X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
Message-ID:	<20170116234147.31491.qmail@rahul.net>
Date:	Mon, 16 Jan 2017 15:41:47 -0800
To:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] Fill clearance?
In-Reply-To:	<da23fee8-1f1c-0251-f2e4-11bc8140662a@ecosensory.com>
References:	<20170116220309 DOT 27757 DOT qmail AT rahul DOT net>
	<da23fee8-1f1c-0251-f2e4-11bc8140662a AT ecosensory DOT com>
X-Mailer:	VM 7.19 under Emacs 23.4.1
From:	conover AT rahul DOT net (John Conover)
MIME-Version:	1.0
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

Thanks, John. Select->Select all visable objects, on the layer works
too.

    John

John Griessen (john AT ecosensory DOT com) [via geda-user AT delorie DOT com] writes:
> On 01/16/2017 04:03 PM, John Conover wrote:
> > In pcb(1), a rectangular fill clearance is about 20 mils, fill to
> > active circuitry.
> >
> > How can this be changed to 25 mil?
> 
> draw a rectangle of component layer,
> put it over the footprint,
> area select all of that,
> start action commands with :
> 
> the type:
> 
> changeclearsize(selectedobjects, 25, mil)
> 

-- 

John Conover, conover AT rahul DOT net, http://www.johncon.com/

- Raw text -