X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
Message-ID:	<20161015082035.25529.qmail@rahul.net>
Date:	Sat, 15 Oct 2016 01:20:35 -0700
To:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] Best way to use gerbv(1) for single layer DIY boards?
In-Reply-To:	<20161015040106.48C8B812661A@turkos.aspodata.se>
References:	<20161012013026 DOT 25221 DOT qmail AT rahul DOT net>
	<20161012023951 DOT 43F528126612 AT turkos DOT aspodata DOT se>
	<526c176c-62b4-9219-3919-83df144acc37 AT ecosensory DOT com>
	<20161015040106 DOT 48C8B812661A AT turkos DOT aspodata DOT se>
X-Mailer:	VM 7.19 under Emacs 23.4.1
From:	conover AT rahul DOT net (John Conover)
MIME-Version:	1.0
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

karl AT aspodata DOT se writes:
> > On 10/11/2016 09:39 PM, karl AT aspodata DOT se wrote:
> > > I get the drill-helper so I can aim better when drilling.

Thanks, Karl.

I need to send the postscript file to a commercial service to make the
transparencies.

Is there a way to cut out the solder layer from the postscript file
separately?

Gimp(1) seems to work, (however, I'm losing resolution with all the
import/export manipulations.) Is there another way?

    Thanks,

    John

-- 

John Conover, conover AT rahul DOT net, http://www.johncon.com/

- Raw text -