X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
X-Mailer:	exmh version 2.8.0 04/21/2012 (debian 1:2.8.0~rc1-2) with nmh-1.5
X-Exmh-Isig-CompType:	repl
X-Exmh-Isig-Folder:	inbox
From:	karl AT aspodata DOT se
To:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] Best way to use gerbv(1) for single layer DIY boards?
In-reply-to:	<20161012013026.25221.qmail@rahul.net>
References:	<20161012013026 DOT 25221 DOT qmail AT rahul DOT net>
Comments:	In-reply-to conover AT rahul DOT net (John Conover)
	message dated "Tue, 11 Oct 2016 18:30:25 -0700."
Mime-Version:	1.0
Message-Id:	<20161012023951.43F528126612@turkos.aspodata.se>
Date:	Wed, 12 Oct 2016 04:39:51 +0200 (CEST)
X-Virus-Scanned:	ClamAV using ClamSMTP
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

John Connover:
> Is this the best way to use gerbv(1) for producing laser printer
> transparencies:
...

Can't help you with the gerbv question; I do it directly from
the pcb file:

pcb -x ps --drill-helper --media A4 --drill-copper --show-legend --multi-file --mirror  file.pcb
lpr file.top.ps file.botom.ps

then I get the drill-helper so I can aim better when drilling.

Regards,
/Karl Hammar

-----------------------------------------------------------------------
Aspö Data
Lilla Aspö 148
S-742 94 Östhammar
Sweden
+46 173 140 57

- Raw text -