X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
Date:	Thu, 19 May 2016 01:25:11 -0400
Message-Id:	<201605190525.u4J5PBoX030635@envy.delorie.com>
From:	DJ Delorie <dj AT delorie DOT com>
To:	geda-user AT delorie DOT com
In-reply-to:	<1463635108.16360.8.camel@ksys.co.nz> (message from Buzz on Thu,
	19 May 2016 17:18:28 +1200)
Subject:	Re: [geda-user] Metric
References:	<1463635108 DOT 16360 DOT 8 DOT camel AT ksys DOT co DOT nz>
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

> Is there a way to get PCB to default to using mm rather than mils?

You can set the default grid to a mm grid in your ~/.pcb/settings:

grid = 1mm
grid-units = mm

- Raw text -