delorie.com/archives/browse.cgi | search |
X-Authentication-Warning: | delorie.com: mail set sender to geda-user-bounces using -f |
X-Recipient: | geda-user AT delorie DOT com |
X-Virus-Status: | Clean |
X-Virus-Scanned: | clamav-milter 0.98.4 at av01.lsn.net |
Subject: | Re: [geda-user] Re: Positive discussion topic thread |
To: | geda-user AT delorie DOT com |
References: | <CAJXU7q8BsPKicvAgFvaigLBmT9CS3dJ_eFYR84mwWEg-=Vyg8Q AT mail DOT gmail DOT com> |
<CAJXU7q9RrJO8=rLG5rdnH_MHQRCO8oghxoGrsao7NfSMEPb+0A AT mail DOT gmail DOT com> | |
<20151230181538 DOT 32790b5b AT jive DOT levalinux DOT org> | |
<201512310212 DOT tBV2C3MK029574 AT envy DOT delorie DOT com> | |
<20151231024721 DOT GC19555 AT localhost DOT localdomain> | |
<CANDNR8qUCtttCn=euybPM0Zga+zv97Hxk5NO21HowX5p7pADAQ AT mail DOT gmail DOT com> | |
<CAKakQcdOFQrM5_K8JtG++AuYcOmNk8+PTMgwLM_RQTZ0woKHSw AT mail DOT gmail DOT com> | |
From: | John Griessen <john AT ecosensory DOT com> |
Message-ID: | <5687F135.3060802@ecosensory.com> |
Date: | Sat, 2 Jan 2016 09:48:05 -0600 |
User-Agent: | Mozilla/5.0 (X11; Linux x86_64; rv:38.0) Gecko/20100101 |
Icedove/38.4.0 | |
MIME-Version: | 1.0 |
In-Reply-To: | <CAKakQcdOFQrM5_K8JtG++AuYcOmNk8+PTMgwLM_RQTZ0woKHSw@mail.gmail.com> |
Reply-To: | geda-user AT delorie DOT com |
Errors-To: | nobody AT delorie DOT com |
X-Mailing-List: | geda-user AT delorie DOT com |
X-Unsubscribes-To: | listserv AT delorie DOT com |
On 12/31/2015 03:59 PM, Stephen Ecob (stephen DOT ecob AT sioi DOT com DOT au) [via geda-user AT delorie DOT com] wrote: > perhaps it could be gcb. I like gcb -- it's unique enough and would make sense as an acronym: gnu circuit board, since they are not all printed, some are milled, some holes are laser drilled, resist patterns are now usually direct imaged instead of photogravure "printed" Printing still captures the essence of board fabbing though, and is being used for 3D fabbing now, (3DP), so gpcb is good also.
webmaster | delorie software privacy |
Copyright © 2019 by DJ Delorie | Updated Jul 2019 |