X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
X-Virus-Scanned:	amavisd-new at neurotica.com
X-NSA-prism-xkeyscore:	I do not consent to surveillance, prick
DKIM-Signature:	v=1; a=rsa-sha256; c=relaxed/simple; d=neurotica.com;
	s=default; t=1421734659;
	bh=ZHvGss46FifAw2/cehy1RGH5ULN/2ZRUtgTFYdponP8=;
	h=Date:From:To:Subject;
	b=eR2lMwUxtc68tIX2fds2Wrx923SPax6DHTAv/LZA4Jq2OP1yEf4kPJ0FFtxda+aiY
	i/RTFcQc7zWOEKUYb604iv0Fhhfci4MrTs+DgoZ4mNd1hM0Cj9wjKm1PCH4DZCHn2W
	QMg37AtKdsvVYbcr25LNCksVQbamwPxls+mwcNGo=
Message-ID:	<54BDF302.9030903@neurotica.com>
Date:	Tue, 20 Jan 2015 01:17:38 -0500
From:	Dave McGuire <mcguire AT neurotica DOT com>
User-Agent:	Mozilla/5.0 (X11; Linux x86_64; rv:31.0) Gecko/20100101 Thunderbird/31.3.0
MIME-Version:	1.0
To:	geda-user AT delorie DOT com
Subject:	[geda-user] possibly dumb PCB question
Reply-To:	geda-user AT delorie DOT com

  Hey folks.  I am drawing a footprint for a surface-mount component
that has two pads with fairly wide spacing between them, and I must not
have any copper (i.e., from the power/ground planes) between them.  Is
there any way I can specify this in the footprint?  I've noodled on it
for awhile and just can't figure it out; I suspect it's something easy
but it's just not presenting itself.  Anyone have any advice?

             Thanks,
             -Dave

-- 
Dave McGuire, AK4HZ/3
New Kensington, PA

- Raw text -