X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
Date:	Tue, 4 Nov 2014 07:41:25 +0100 (CET)
X-X-Sender:	igor2 AT igor2priv
To:	geda-user AT delorie DOT com
X-Debug:	to=geda-user AT delorie DOT com from="gedau AT igor2 DOT repo DOT hu"
From:	gedau AT igor2 DOT repo DOT hu
Subject:	Re: [geda-user] PCB gcode export - several questions
In-Reply-To:	<8S9.Jcc6.3vpUCOOwqUA.1KM6P6@seznam.cz>
Message-ID:	<alpine.DEB.2.00.1411040736580.3358@igor2priv>
References:	<8S9 DOT Jcc6 DOT 3vpUCOOwqUA DOT 1KM6P6 AT seznam DOT cz>
User-Agent:	Alpine 2.00 (DEB 1167 2008-08-23)
MIME-Version:	1.0
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

Hi,
On Tue, 4 Nov 2014, Vaclav Peroutka wrote:

>Hello,

<snip (I have no experneice with gcode)>

>
>How can I create non-rectangular holes to be milled (for some mechanical
>components)?

PCB doesn't support non-circular holes. What I usually do is defining a 
layer (or just use the outline layer) and set up a style with a line width 
matching the diameter of the drill bit then draw the path. PCB will take 
this as a copper layer (with some side effects if it's called outline), 
but at the end these "traces" are easy to use for milling. At least this 
was my experience with gerber and a fab house.


Regards,

Igor2

- Raw text -