delorie.com/archives/browse.cgi | search |
X-Authentication-Warning: | delorie.com: mail set sender to geda-user-bounces using -f |
X-Recipient: | geda-user AT delorie DOT com |
X-Virus-Scanned: | amavisd-new at neurotica.com |
X-NSA-prism-xkeyscore: | I do not want to be surveilled |
Message-ID: | <540F349A.8020109@neurotica.com> |
Date: | Tue, 09 Sep 2014 13:10:50 -0400 |
From: | Dave McGuire <mcguire AT neurotica DOT com> |
User-Agent: | Mozilla/5.0 (X11; Linux x86_64; rv:31.0) Gecko/20100101 Thunderbird/31.0 |
MIME-Version: | 1.0 |
To: | geda-user AT delorie DOT com |
Subject: | Re: [geda-user] Hanwei sensor footprints? |
References: | <540E09A3 DOT 20903 AT neurotica DOT com> <CANDNR8pEqtW0kJ7zJ66i1vLQFZBftja6SVKswvsTxxGtLCUDwQ AT mail DOT gmail DOT com> |
In-Reply-To: | <CANDNR8pEqtW0kJ7zJ66i1vLQFZBftja6SVKswvsTxxGtLCUDwQ@mail.gmail.com> |
Reply-To: | geda-user AT delorie DOT com |
On 09/09/2014 03:35 AM, Atommann wrote: > 2014-09-09 3:55 GMT+08:00 Dave McGuire <mcguire AT neurotica DOT com>: >> >> Hey folks. Has anyone done up any PCB footprints for any of the >> Hanwei gas sensors, like the MG800 etc, with that six-pin circular pin >> pattern? > > I see people use MQ-6 sockets for this kind of sensor. > https://www.sparkfun.com/products/8891 > https://www.sparkfun.com/products/9405 Yes, I've seen those too. My present application will require that they be soldered to the board, though. -Dave -- Dave McGuire, AK4HZ/3 New Kensington, PA
webmaster | delorie software privacy |
Copyright © 2019 by DJ Delorie | Updated Jul 2019 |