delorie.com/archives/browse.cgi | search |
X-Authentication-Warning: | delorie.com: mail set sender to geda-user-bounces using -f |
X-Recipient: | geda-user AT delorie DOT com |
X-Envelope-From: | paubert AT iram DOT es |
Date: | Tue, 9 Sep 2014 08:35:55 +0200 |
From: | Gabriel Paubert <paubert AT iram DOT es> |
To: | geda-user AT delorie DOT com |
Subject: | Re: [geda-user] Hanwei sensor footprints? |
Message-ID: | <20140909063555.GA16379@visitor2.iram.es> |
References: | <540E09A3 DOT 20903 AT neurotica DOT com> |
<lul5q2$mv4$1 AT ger DOT gmane DOT org> | |
MIME-Version: | 1.0 |
In-Reply-To: | <lul5q2$mv4$1@ger.gmane.org> |
User-Agent: | Mutt/1.5.21 (2010-09-15) |
X-Spamina-Bogosity: | Ham |
Reply-To: | geda-user AT delorie DOT com |
Errors-To: | nobody AT delorie DOT com |
X-Mailing-List: | geda-user AT delorie DOT com |
X-Unsubscribes-To: | listserv AT delorie DOT com |
On Mon, Sep 08, 2014 at 11:08:57PM +0200, Kai-Martin Knaak wrote: > Dave McGuire wrote: > > > > > Hey folks. Has anyone done up any PCB footprints for any of the > > Hanwei gas sensors, like the MG800 etc, with that six-pin circular pin > > pattern? > > I did not find the footprint pattern on their website > http://www.hwsensor.com/English/products.shtml > Maybe somewhere in the much more extensive Chinese section. But Chinese is > all Greek to me ;-) Actually technical greek (modern greek) is not that hard to understand. (Disclaimer: I studied classical greek for 5 years, but modern greek is so different that it is not very helpful). But the english translation pointed to by Dave is so bad that I'd prefer a greek translation done by a native greek speaker :-) This said the footprint looks like an 8 pin circular TO whatever from a few decades ago with 2 pins removed. However the diameter of the circle on which the pins are located is different (much larger), and I've never seen this package in any library. Gabriel
webmaster | delorie software privacy |
Copyright © 2019 by DJ Delorie | Updated Jul 2019 |