X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
Message-ID:	<53FDC4FF.5030704@estechnical.co.uk>
Date:	Wed, 27 Aug 2014 12:46:07 +0100
From:	Ed Simmons <ed AT estechnical DOT co DOT uk>
User-Agent:	Mozilla/5.0 (X11; Linux i686; rv:31.0) Gecko/20100101 Thunderbird/31.0
MIME-Version:	1.0
To:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] pcb: buffer not mirroring a group of SMT resistors
	& their tracks (pcb ver 20110918)
References:	<53FDB13C DOT 9050202 AT envinsci DOT co DOT uk>
In-Reply-To:	<53FDB13C.9050202@envinsci.co.uk>
X-Authenticated-As:	ed AT estechnical DOT co DOT uk
X-Extend-Src:	mailout
Reply-To:	geda-user AT delorie DOT com

On 27/08/14 11:21, Matt Rhys-Roberts wrote:
> Hi, I just wish to left-right mirror a selection of 0805 resistors and
> their tracks. Selecting them, cutting selection to buffer, then using
> either type of 'mirror buffer' function, does not modify the buffer at
> all.
>
> If this worked, it would save me manually repositioning a lot of work,
> which has been caused by moving a thru-hole IC to the non-copper side
> of a single sided board. I'll have to do it manually in the meantime...
>
> Any solutions please? Upgrade imminent...
>
> Regards,
> Matt
>
Hi Matt,

The buffer manipulation only works on tracks when there are no parts
present - since mirroring anything more complex than a resistor results
in invalid pin numbering.

You can probably get the tracks alone to mirror, then place the parts as
needed...

I hope that helps...

Ed

-- 
Ed Simmons
ed AT estechnical DOT co DOT uk
www.estechnical.co.uk

- Raw text -