X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
X-Envelope-From:	paubert AT iram DOT es
Date:	Mon, 24 Feb 2014 10:01:28 +0100
From:	Gabriel Paubert <paubert AT iram DOT es>
To:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] Smallest clearance and mask in pcb
Message-ID:	<20140224090128.GA10606@visitor2.iram.es>
References:	<CALSZ9goatN585wfa0Md_AbTvQgPnKMMMOSkuCVy87ZVB7=F3cA AT mail DOT gmail DOT com>
	<201402232141 DOT s1NLfelF009940 AT envy DOT delorie DOT com>
	<20140224075131 DOT GA19160 AT visitor2 DOT iram DOT es>
MIME-Version:	1.0
In-Reply-To:	<20140224075131.GA19160@visitor2.iram.es>
User-Agent:	Mutt/1.5.21 (2010-09-15)
X-Spamina-Bogosity:	Ham
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

On Mon, Feb 24, 2014 at 08:51:31AM +0100, Gabriel Paubert wrote:
> On Sun, Feb 23, 2014 at 04:41:40PM -0500, DJ Delorie wrote:
> > 
> > I typically leave 3mil between mask and copper.  "clearance" is
> > copper-copper so should be the same as the line/space rules (typically
> > 6-10mil).

Sorry I read the message too fast and should have created another thread
for this problem.

But I concur with DJ, I typically use 75µm (~3mil) for solder mask cleareance,
although I had to go below (down to 60µm] for some 0.5mm pitch devices in a board 
which was fabricated earlier this month. But whether you can do it or not
depends on your PCB house (in the first version the solder mask apertures
were merged).

	Gabriel

- Raw text -