X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
Message-ID:	<5135CB72.50701@estechnical.co.uk>
Date:	Tue, 05 Mar 2013 10:39:46 +0000
From:	Ed Simmons <ed AT estechnical DOT co DOT uk>
User-Agent:	Mozilla/5.0 (X11; Linux x86_64; rv:17.0) Gecko/20130221 Thunderbird/17.0.3
MIME-Version:	1.0
To:	geda-user AT delorie DOT com
CC:	Kai-Martin Knaak <kmk AT familieknaak DOT de>
Subject:	Re: [geda-user] Stencil tooling holes
References:	<51350C42 DOT 2070801 AT estechnical DOT co DOT uk> <20130305054647 DOT 0167672a AT akka>
In-Reply-To:	<20130305054647.0167672a@akka>
X-Authenticated-As:	ed AT estechnical DOT co DOT uk
Reply-To:	geda-user AT delorie DOT com

On 05/03/13 04:46, Kai-Martin Knaak wrote:
> Ed Simmons <ed AT estechnical DOT co DOT uk> schrieb am  4. March 2013:
>
>> Please could someone offer some advice for placing tooling holes into
>> my design (these are off the edges of the board itself and will only
>> be used for stencil layers)
>>
>> How would you go about this? Is this something I should make a custom
>> footprint for?
> IMHO, a special footprint is the best solution. I attached my preferred
> marks to this mail.
>
> ---<)kaimartin(>---
Thanks Kai-Martin,

That looks good...

Looking at these in PCB, it's not obvious how to view the opening of the 
stencil layer, is this possible?

Thanks for your help,
Ed

- Raw text -