X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
Mime-Version:	1.0 (Apple Message framework v1085)
Subject:	Re: [geda-user] geda-skeleton-project: Lowering the cost of a starting a gEDA project
From:	John Doty <jpd AT noqsi DOT com>
In-Reply-To:	<87wqvhd4tw.fsf@gmail.com>
Date:	Sun, 13 Jan 2013 09:02:51 -0700
Message-Id:	<859D19F5-2072-408E-9632-324C2C943163@noqsi.com>
References:	<87wqvhd4tw DOT fsf AT gmail DOT com>
To:	geda-user AT delorie DOT com
X-Mailer:	Apple Mail (2.1085)
X-MIME-Autoconverted:	from quoted-printable to 8bit by delorie.com id r0DG2v4M001038
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

On Jan 12, 2013, at 10:34 PM, Ben Gamari wrote:

>  * a script to automate the initial configuration of the project
>  * a Makefile for performing some common tasks (e.g. generating
>    tragesym symbols, updating the pcb layout, and exporting gerbers)
>  * some documentation describing use of the initialization script and
>    Makefile
>  * further discussion to clarify a few common questions about the
>    toolchain

Since this is pcb-centric rather than geda-centric, I think it would be better to call it "pcb-skeleton-project".

John Doty              Noqsi Aerospace, Ltd.
http://www.noqsi.com/
jpd AT noqsi DOT com

- Raw text -