X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
Message-ID:	<20121011155417.13405.qmail@stuge.se>
Date:	Thu, 11 Oct 2012 17:54:17 +0200
From:	Peter Stuge <peter AT stuge DOT se>
To:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] Flex?
Mail-Followup-To:	geda-user AT delorie DOT com
References:	<20121011143959 DOT 7435 DOT qmail AT stuge DOT se> <1349967212 DOT 2412 DOT 37 DOT camel AT AMD64X2 DOT fritz DOT box>
MIME-Version:	1.0
In-Reply-To:	<1349967212.2412.37.camel@AMD64X2.fritz.box>
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

Stefan Salewski wrote:
> http://www.delorie.com/pcb/teardrops/
> 
> I am not sure if it works perfectly, someone reported about a
> problem long time ago, I do not know if DJ has fixed that.

http://stuge.se/tears.png

It looks absolutely beautiful for vias and round pads.

I only have pads on the flex board however, and on square pads the
result is not as convincing.

What is the solution? I guess the arcs need to start further out
towards the corners. (One half line width diagonally in from each
corner.)


//Peter

- Raw text -