X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
Message-ID:	<5010D52B.8030800@plastitar.com>
Date:	Thu, 26 Jul 2012 01:27:07 -0400
From:	Phil Taylor <phil AT plastitar DOT com>
User-Agent:	Mozilla/5.0 (Windows NT 6.1; WOW64; rv:9.0) Gecko/20111222 Thunderbird/9.0.1
MIME-Version:	1.0
To:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] how to use "clearance" and mask in pcb footprint
References:	<CA+GuLwe5sPPWJQAQtX2mYTFYz5Dnt_wPy42ywZnY37dagsrEHQ AT mail DOT gmail DOT com>
In-Reply-To:	<CA+GuLwe5sPPWJQAQtX2mYTFYz5Dnt_wPy42ywZnY37dagsrEHQ@mail.gmail.com>
X-HR-Scan-Signature:	7d2c30c72ca6c31c764b039101f8f1f8
X-HR-ClamAV-Scan:	Clear
X-HR-SA-Score:	0.0 (/)
X-HR-Status:	Normal-(phil AT plastitar DOT com/66.147.237.116)
Reply-To:	geda-user AT delorie DOT com

On 7/25/2012 12:05 PM, Ram Bhamidipaty wrote:
> I'm pretty sure the way I am doing the pins with the mask and clearance
> values is wrong. Are there some general rules I should follow for solder mask
> and clearance values? Are clearance and mask values dependent on the
> board fab rules?

Ram,

This document explains the clearance and mask numbers ... which are not 
as obvious as you might at first think.

The design rules in PCB do not modify file footprints.  The footprints 
are what they are ... when you write them.  This would pertain to 
text-written file type footprints.  I have no idea about footprints 
created in PCB's gui.

Phil

- Raw text -