X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
X-Mail-Handler:	MailHop Outbound by DynDNS
X-Originating-IP:	99.160.157.208
X-Report-Abuse-To:	abuse AT dyndns DOT com (see http://www.dyndns.com/services/mailhop/outbound_abuse.html for abuse reporting information)
X-MHO-User:	U2FsdGVkX1/jtHTusdge8ft/PpPhJLNh
Date:	Mon, 19 Mar 2012 01:30:44 -0700 (PDT)
From:	David Griffith <dave AT 661 DOT org>
To:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] soldermask and edge connectors
In-Reply-To:	<4F66D542.3050404@keensupport.net>
Message-ID:	<alpine.DEB.2.00.1203190126470.23342@zaphod.661.org>
References:	<1332124007 DOT 10525 DOT 0 AT kwak> <alpine DOT DEB DOT 2 DOT 00 DOT 1203182229570 DOT 23342 AT zaphod DOT 661 DOT org> <4F66D542 DOT 3050404 AT keensupport DOT net>
User-Agent:	Alpine 2.00 (DEB 1167 2008-08-23)
MIME-Version:	1.0
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

On Sun, 18 Mar 2012, Joe Knapp wrote:

> On 03/18/2012 10:33 PM, David Griffith wrote:
>> On Mon, 19 Mar 2012, Kai-Martin wrote:
>>
>>> On 03/19/2012 02:32:12 AM, David Griffith wrote:
>>>>
>>>> I'm trying to make an edge connector footprint.  First, I want to
>>>> make sure that the soldermask is clear of the fingers except at the
>>>> root where traces connect.
>>>
>>> Do the connector footprint with two pads per finger. Reduce mask size
>>> of one pad to zero vie the command line interface.
>>
>> I tried this and the result was soldermask going everywhere but the
>> finger.  I want the entire area where the fingers are clear of
>> soldermask. I can do that by increasing the mask clearance, but I get
>> scalloped edges.

I think I garbled myself with this one.  When I converted the buffer to an 
element, I then changed the pins from round to square.  This cured the 
problem of scalloped edged of soldermask.  I still have a problem with the 
need to cover part of the fingers with soldermask.  There's also an issue 
with soldermask.  Two fingers are longer than the rest, extending to the 
very edge of board whereas the other fingers are set back slightly.  How 
can I make sure the empty area between the fingers and the edge is kept 
clear of soldermask?

-- 
David Griffith
dave AT 661 DOT org

- Raw text -