X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
Date:	Thu, 15 Dec 2011 11:39:54 -0800
From:	Andrew Poelstra <asp11 AT sfu DOT ca>
To:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] pcb gerbers not correct
Message-ID:	<20111215193954.GA22563@malakian.lan>
References:	<4EDED68C DOT 90607 AT optonline DOT net>
	<CAHu0Z0WPdPno8A0Vo3pTOm77FdP+ncDcsy6Z=cp+8aPOz64rpA AT mail DOT gmail DOT com>
MIME-Version:	1.0
In-Reply-To:	<CAHu0Z0WPdPno8A0Vo3pTOm77FdP+ncDcsy6Z=cp+8aPOz64rpA@mail.gmail.com>
User-Agent:	Mutt/1.5.20 (2009-12-10)
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

On Wed, Dec 07, 2011 at 02:57:42PM +0000, Justyn Butler wrote:
> I'm seeing exactly the same problem.
> 
> I have a 550mm x 18mm board that was created using gsch2pcb 1.6.2 and
> routed with pcb 20110918.
> When exporting the gerbers, the plated drill layer is significantly
> misplaced, the rest of the layers look fine (although I've not double
> checked that).
> 
> Exporting the same board from 20100929 produces no problems.
> 
> I am also on a 32-bit system.
>

Confirmed with a 550x250 mm board when compiling with --enable-coord32.
(Conversely, confirmed that it -doesn't- happen with a 64-bit compile.)
The other layers are fine, just not the plated drills.

I'll look into this. Thanks for your report.

-- 
Andrew Poelstra
Email: asp11 at sfu.ca OR apoelstra at wpsoftware.net
Web:   http://www.wpsoftware.net/andrew
"I don't understand. Are you saying dualism is always good, or always bad?"

- Raw text -