X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
MIME-Version:	1.0
In-Reply-To:	<281620.2144.4836-20539-1049559468-1316547115@seznam.cz>
References:	<281620 DOT 2144 DOT 4836-20539-1049559468-1316547115 AT seznam DOT cz>
Date:	Tue, 20 Sep 2011 13:47:03 -0700
Message-ID:	<CAN0Jx--oFwRsXXV_GZDwBWb0SBKwoEYw_inFh0W-NRYqruDONQ@mail.gmail.com>
Subject:	Re: PCB - moving already routed objects
From:	Russell Dill <Russ DOT Dill AT asu DOT edu>
To:	geda-user AT delorie DOT com
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

On Tue, Sep 20, 2011 at 12:31 PM, Vaclav Peroutka <vaclavpe AT seznam DOT cz> wrote:
>
> Hello,
>
> I have one problem. I am finishing one PCB but I have to move one TQFP to
> connect last signal. So - I have to delete routed signals around the footprint,
> move the footprint, move end points of remaining tracks to have more room and
> re-route again.
>
> Is there any simpler, more automatic method? I would imagine that I pick and
> move footprint and PCB computes possible position regarding tracks around it and
> clearance. Holding 45 deg tracks. It might be hard to describe. I attached one
> picture. I know that there is a plenty of possibilities. But is there any plan
> to support at least some smart moving of routed footprints?
>

Ah yes, closely related to pushing tracks. I'm aware that it is one of
the long term goals, but it does require quite a bit of dedicated time
to implement.

In the meantime, you might try deleting some tracks, moving the
component, optimizing the rats, and then invoking the autorouter.

- Raw text -