delorie.com/archives/browse.cgi   search  
Mail Archives: geda-help/2011/09/23/19:26:06

X-Authentication-Warning: delorie.com: mail set sender to geda-help-bounces using -f
X-Recipient: geda-help AT delorie DOT com
DKIM-Signature: v=1; a=rsa-sha256; c=relaxed/relaxed;
d=gmail.com; s=gamma;
h=mime-version:in-reply-to:references:date:message-id:subject:from:to
:content-type;
bh=7A9Zp6RpKXhoiq7owshKYovpUDc5KUIZwySqBarnS7c=;
b=nsjT+FBdeNs86J9BG+wGK2J5FuPe+Ba4lcMAwl1PKQ0Gy37biHn7dk523QV0jR9kEN
BfMjeByDW4E0PHUPyEJWhbob71U61DT2EXcynO3QPzDYt+ud3hktnO/LNwk3G9w/9Ufh
stV40Q94xDYP0q6EeaDWfVLvH9i+/Efzw8hug=
MIME-Version: 1.0
In-Reply-To: <201109231851.p8NIpO7B004069@envy.delorie.com>
References: <alpine DOT DEB DOT 2 DOT 00 DOT 1109231414110 DOT 3448 AT juneau DOT me DOT vt DOT edu>
<201109231851 DOT p8NIpO7B004069 AT envy DOT delorie DOT com>
Date: Fri, 23 Sep 2011 19:25:59 -0400
Message-ID: <CAPYb0EH1LOgff53a9zTN0qXJaw7bfzcNzO20Z083MLFie1PPvw@mail.gmail.com>
Subject: Re: [geda-help] Preferred way "Separate-but-equal" grounds
From: Bob Paddock <bob DOT paddock AT gmail DOT com>
To: geda-help AT delorie DOT com
Reply-To: geda-help AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-help AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com

>> - I've got a mixed-signal board where I've got an AGND, PGND, and DGND
>> which I want to be routed separately (different trace widths, etc).
>> However, I want them to be connected at one point (that I would chose).
>> What's the correct way to do this?
>
> So far, the "best" answer is: talk to your layout guy :-)
>
> There is no technical solution to this one in the geda/pcb tools.

I use a zero Ohm resistor, with a footprint that will get covered in
solder to short the two closely spaced pads.

- Raw text -


  webmaster     delorie software   privacy  
  Copyright © 2019   by DJ Delorie     Updated Jul 2019