delorie.com/archives/browse.cgi   search  
Mail Archives: geda-help/2020/11/23/00:46:02

X-Authentication-Warning: delorie.com: mail set sender to geda-help-bounces using -f
X-Recipient: geda-help AT delorie DOT com
X-Mailer: exmh version 2.8.0 04/21/2012 with nmh-1.7+dev
X-Exmh-Isig-CompType: repl
X-Exmh-Isig-Folder: inbox
From: "karl AT aspodata DOT se [via geda-help AT delorie DOT com]" <geda-help AT delorie DOT com>
To: geda-help AT delorie DOT com
Subject: Re: [geda-help] use own m4 footprints in pcb
In-reply-to: <98752ff6-19fa-b003-a3a1-b4260cbbd450@gmx.de>
References: <98752ff6-19fa-b003-a3a1-b4260cbbd450 AT gmx DOT de>
Comments: In-reply-to "Klaus Rudolph (lts-rudolph AT gmx DOT de) [via geda-help AT delorie DOT com]" <geda-help AT delorie DOT com>
message dated "Sat, 21 Nov 2020 19:25:18 +0100."
Mime-Version: 1.0
Message-Id: <20201123053114.12CDA824403B@turkos.aspodata.se>
Date: Mon, 23 Nov 2020 06:31:14 +0100 (CET)
X-Virus-Scanned: ClamAV using ClamSMTP
Reply-To: geda-help AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-help AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com

Klaus:
> I still search a way how to integrate own m4 footprints to pcb.
> 
> I am able to use own m4 footprints in connection with gsch2pcb, but I
> still not able to select a self created footprint in pcb itself from the
> library window.
> 
> Any hint is very welcome...

There is a section in the manual ([1]) about that, see e.g. [2].

The m4 footprints is an example of footprint generation, see [3] for
other generators that might be of interest for you.

[1] http://pcb.geda-project.org/manual.html
[2] http://pcb.geda-project.org/pcb-4.2.0/pcb.html#Library-Creation
[3] http://wiki.geda-project.org/pcb:footprint_generators

Regards,
/Karl Hammar

- Raw text -


  webmaster     delorie software   privacy  
  Copyright © 2019   by DJ Delorie     Updated Jul 2019