delorie.com/archives/browse.cgi | search |
X-Authentication-Warning: | delorie.com: mail set sender to geda-help-bounces using -f |
X-Authentication-Warning: | envy.delorie.com: dj set sender to dj AT delorie DOT com using -f |
From: | DJ Delorie <dj AT delorie DOT com> |
To: | geda-help AT delorie DOT com |
Subject: | Re: [geda-help] PCB: bottom layer split |
In-Reply-To: | <alpine.LFD.2.20.1901131708510.24356@kai.zorinco.com> (geda-help@delorie.com) |
Date: | Sun, 13 Jan 2019 20:20:36 -0500 |
Message-ID: | <xnmuo4dogr.fsf@envy.delorie.com> |
MIME-Version: | 1.0 |
Reply-To: | geda-help AT delorie DOT com |
Errors-To: | nobody AT delorie DOT com |
X-Mailing-List: | geda-help AT delorie DOT com |
X-Unsubscribes-To: | listserv AT delorie DOT com |
"Christopher Nielsen (chris AT zorinco DOT com) [via geda-help AT delorie DOT com]" <geda-help AT delorie DOT com> writes: > But this is not saved? If I save the pcb and open again then file->export > gerbers, it's back to the bottom layer missing the traces (on a different > board)... It definitely should be saved. There'll be a line in your *.pcb like this: Groups("1,c:2:3:4:5:6,s:7:8") You can manually edit the *.pcb in case it's corrupted that line in a way that it doesn't save it right, but I don't recall that ever happening.
webmaster | delorie software privacy |
Copyright © 2019 by DJ Delorie | Updated Jul 2019 |