X-Authentication-Warning:	delorie.com: mail set sender to geda-help-bounces using -f
X-Recipient:	geda-help AT delorie DOT com
Message-ID:	<20160102130543.20695.qmail@stuge.se>
Date:	Sat, 2 Jan 2016 14:05:43 +0100
From:	"Peter Stuge (peter AT stuge DOT se) [via geda-help AT delorie DOT com]" <geda-help AT delorie DOT com>
To:	"geda-help AT delorie DOT com" <geda-help AT delorie DOT com>
Subject:	Re: [geda-help] Trying to use PCB
Mail-Followup-To:	"geda-help AT delorie DOT com" <geda-help AT delorie DOT com>
References:	<2117881152 DOT 5984119 DOT 1451726165092 DOT JavaMail DOT yahoo DOT ref AT mail DOT yahoo DOT com> <2117881152 DOT 5984119 DOT 1451726165092 DOT JavaMail DOT yahoo AT mail DOT yahoo DOT com>
MIME-Version:	1.0
In-Reply-To:	<2117881152.5984119.1451726165092.JavaMail.yahoo@mail.yahoo.com>
Reply-To:	geda-help AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-help AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

Hi Stefanos,

S Kiakas (skiakas AT yahoo DOT ca) [via geda-help AT delorie DOT com] wrote:
> I am trying to use PCB on FreeBSD 10.2 from their ports collection.
..
> When I try to create a printed circuit board: I add an SMD foot
> print for 0805 resistor, save to a file, then open it again, the
> foot print is wrong. (See image attached below. )

This is a bug.


> Does anyone else have this problem?

I haven't seen this problem, but I also haven't used your version.


> Why is -30mils converted to -0.2377mm?

The unit is changed because newer versions switched to using nm
coordinates internally.

The calculation error is a bug. It might be the same bug that messes
up the 0805.


> I am new to PCB. So maybe I miss understood something.

Nono, you're doing super basic things that should work just fine.

Can you try building the very latest source?


Kind regards

//Peter

- Raw text -