X-Authentication-Warning:	delorie.com: mail set sender to geda-help-bounces using -f
X-Recipient:	geda-help AT delorie DOT com
Message-ID:	<20111212214103.14650.qmail@stuge.se>
Date:	Mon, 12 Dec 2011 22:41:03 +0100
From:	Peter Stuge <peter AT stuge DOT se>
To:	geda-help AT delorie DOT com
Subject:	[geda-help] Creating a T-shaped pad in PCB
MIME-Version:	1.0
Reply-To:	geda-help AT delorie DOT com

--jousvV0MzM2p6OtC
Content-Type: text/plain; charset=us-ascii
Content-Disposition: inline

Hi!

I've used PCB on and off for lots of years, and used gschem for much
fewer years. Has some quirks, but especially the last years the
development is amazing.

I've now made a TO263 footprint with a T-shaped pad for the tab, but
I'm not sure that I've gotten it really right, because my (old) PCB
version sometimes renders the two parts of the pad with a (small) gap
between them.

Please review the attached footprint. How to do it right? Or am I
worrying for nothing, and output will always have pads coalesced?


//Peter

--jousvV0MzM2p6OtC
Content-Type: text/plain; charset=us-ascii
Content-Disposition: attachment; filename="TO263_5PIN.fp"

Element[0x00000000 "TO263_5PIN" "" "" 0 0 -31525 -30000 0 100 ""]
(
	Pad[-26275 -17500 -26275 17500 7500 8500 9500 "" "3" "square"]
	Pad[-12525 -6400 -12525 6400 20000 21000 22000 "" "3" "square"]

	Pad[24225 -13400 27925 -13400 4200 5200 6200 "" "5" "square"]
	Pad[24225  -6700 27925  -6700 4200 5200 6200 "" "4" "square"]
	Pad[24225      0 27925      0 4200 5200 6200 "" "3" "square"]
	Pad[24225   6700 27925   6700 4200 5200 6200 "" "2" "square"]
	Pad[24225  13400 27925  13400 4200 5200 6200 "" "1" "square"]

	ElementLine[-31525 -22750  31525 -22750 1000]
	ElementLine[ 31525 -22750  31525  22750 1000]
	ElementLine[ 31525  22750 -31525  22750 1000]
	ElementLine[-31525  22750 -31525 -22750 1000]
)

--jousvV0MzM2p6OtC--

- Raw text -