Message-Id:	<m0wKkGM-000S1sC@natacha.inti.edu.ar>
Comments:	Authenticated sender is <salvador AT natacha DOT inti DOT edu DOT ar>
From:	"Salvador Eduardo Tropea (SET)" <salvador AT inti DOT edu DOT ar>
Organization:	INTI
To:	Adrian Oboroc <oboroc AT usm DOT md>,
	Robert Hoehne <robert DOT hoehne AT mathematik DOT tu-chemnitz DOT de>,
	djgpp AT delorie DOT com, hcarty AT ccpl DOT carr DOT lib DOT md DOT us
Date:	Fri, 25 Apr 1997 15:54:50 +0000
MIME-Version:	1.0
Subject:	Re: RHIDE screen problems

Adrian wrote:
> On Wed, 23 Apr 1997, Hez Carty wrote:
> 
> > Robert Hoehne wrote:
> > 
> >   On Tue, 22 Apr 1997, Hez Carty wrote:
> > 
> >   > strange problem.  If it helps, I'm loading Univbe 5.3 from my
> >   > autoexec.bat, and my video card has a Cirrus Logic 5446 chip.
> >   Thanks in
> > 
> >   Have you tried RHIDE without Univbe?? (I know that this piece of
> >   software is buggy because it does not handle all the standard
> >   BIOS functions correct, and I use the specification from R. Brown's
> >   Interrupt List).
> > 
> >   And the next hint can be to use the '-G 1' switch for RHIDE, that
> >   means,
> >   run RHIDE like:
> > 
> >   rhide -G 1 ....
> >  
> >   I tried booting clean, with only proper environment variables set, but
> > the b\problem was still there.  I'm really getting a little confused now
> > as to what could be causing the problem.  Any more ideas? Please? :-)
> 
> I have similar problems, and I use CL5446 too. I don't use UniVbe. -G 1
> switch does not resolves the problem. Since problem appears only on that
> specific videocard I think that RHIDE use some VBE functions wich are not
> implemented in video-bios. All other programs works perfectly, so hardware
> isn't too buggy.
All the calls are standard but we don't checked if some flag allows to the BIOS 
to say that some of the functions isn't supported. Perhaps the CL5446 lack the 
routine to save/restore the board registers.
 
> Another problem: then I exit from RHIDE while debugging graphics program,
> wich works in 640x480x256 videomode, it does not restore text mode, and
> all I have is a nice black screen until reboot. I use v1.2.
If you (Robert) don't understand it I'll clarify:
He wants to force a restore of the same mode that was set when RHIDE started. 
So if he enters in mode 3 and leaves in mode 0x101 he wants that RHIDE restore 
the original mode 3.

SET
 
------------------------------------ 0 --------------------------------
Visit my home page: http://www.geocities.com/SiliconValley/Vista/6552/
Salvador Eduardo Tropea (SET). (Electronics Engineer)
Address: Curapaligue 2124, Caseros, 3 de Febrero
Buenos Aires, (1678), ARGENTINA
TE: +(541) 759 0013

- Raw text -