From:	gfoot AT mc31 DOT merton DOT ox DOT ac DOT uk (George Foot)
Newsgroups:	comp.os.msdos.djgpp
Subject:	Re: Troubleshooting: There were some errors...
Date:	4 Mar 1997 10:28:44 GMT
Organization:	Oxford University
Lines:	15
Message-ID:	<5fgtgs$r28@news.ox.ac.uk>
References:	<3 DOT 0 DOT 1 DOT 16 DOT 19970303220311 DOT 28bfed74 AT mail DOT geocities DOT com>
NNTP-Posting-Host:	mc31.merton.ox.ac.uk
To:	djgpp AT delorie DOT com
DJ-Gateway:	from newsgroup comp.os.msdos.djgpp

Mike Orbinpost (m_orbinpost AT geocities DOT com) wrote:
: When I try to compile a .c file under RHIDE, it starts to compile and then
: it stops and the message box says "There were some errors".  How do I go
: about locating those errors so that I can correct them?  I have compiled
: this same source under Turbo C for DOS ver 3.0 without any errors or warnings.

It should give the error messages in the message box, above the line you
quoted. At least it does for me. One thing which springs to mind (I can't
test this ATM) is that you are trying to compile a single file. Previous
versions of RHIDE have required that you set up a project, even if it only
has one file in it; I'm not sure about the current version.

-- 
George Foot <gfoot AT mc31 DOT merton DOT ox DOT ac DOT uk>
Merton College, Oxford.

- Raw text -