Date:	Tue, 26 Sep 1995 15:40:25 +22305931 (WAUST)
From:	Ron Grunwald <rgrunwal AT bluering DOT cowan DOT edu DOT au>
Sender:	Ron Grunwald <rgrunwal AT bluering DOT cowan DOT edu DOT au>
Reply-To:	Ron Grunwald <rgrunwal AT bluering DOT cowan DOT edu DOT au>
Subject:	Re: OBJ2COFF -> Here it is!
To:	Jan Oonk <jan AT stack DOT urc DOT tue DOT nl>
Cc:	djgpp AT sun DOT soe DOT clarkson DOT edu

On 25 Sep 1995, Jan Oonk wrote:

> Finally!! Here it is .... The object 2 coff converter (o2c)
> We were very busy with our study here at HSE ! Not :)
> 
> 
> This message was sent by Trax/SPiRiT!
> Please EMAIL all replys to Jan AT stack DOT urc DOT tue DOT nl


I've just had a quick try of your OBJ-to-COFF converter, using a simple
assembly file which was compiled under TASM V3.1.

Command line was: o2c gpf.obj


However, I got the error message:

"Object-file must be flat-modelled!", and no output file (.o) was written.
What does this error refer to?


Regards, Ron.



 ********************************************************************
 | Author.............. Ron Grunwald                                | 
 | Internet............ rgrunwal AT bluering DOT cowan DOT edu DOT au              |
 | Phone............... (09)273 8027 or (09)273 8468                |
 |------------------------------------------------------------------|
 | Department.......... Computer Operations and Systems Management  |
 | Division/Faculty.... Information Technology                      | 
 | Institute........... Edith Cowan University, Churchlands         | 
 | Location............ Perth, Western Australia                    |
 ********************************************************************
 "I don't have any solution but I certainly admire the problem!"

- Raw text -