X-Recipient:	archive-cygwin AT delorie DOT com
X-SWARE-Spam-Status:	Yes, hits=6.2 required=5.0 tests=AWL,BAYES_40,BOTNET,RCVD_IN_DNSWL_NONE,SPF_NEUTRAL
X-Spam-Check-By:	sourceware.org
Message-id:	<0LDK00NTGSOP1XA1@vms173001.mailsrvcs.net>
Date:	Fri, 17 Dec 2010 09:09:28 -0500
To:	Ross Hemingway <rossh AT rosshemail DOT com>, cygwin AT cygwin DOT com
From:	"Pierre A. Humblet" <Pierre DOT Humblet AT ieee DOT org>
Subject:	Re: Errors in Exim, rebaseall, inetd.
In-reply-to:	<4D0B4DA5.8060800@rosshemail.com>
References:	<1292583706 DOT 6437 DOT ezmlm AT cygwin DOT com> <4D0B4DA5 DOT 8060800 AT rosshemail DOT com>
MIME-version:	1.0
Mailing-List:	contact cygwin-help AT cygwin DOT com; run by ezmlm
List-Id:	<cygwin.cygwin.com>
List-Unsubscribe:	<mailto:cygwin-unsubscribe-archive-cygwin=delorie DOT com AT cygwin DOT com>
List-Subscribe:	<mailto:cygwin-subscribe AT cygwin DOT com>
List-Archive:	<http://sourceware.org/ml/cygwin/>
List-Post:	<mailto:cygwin AT cygwin DOT com>
List-Help:	<mailto:cygwin-help AT cygwin DOT com>, <http://sourceware.org/ml/#faqs>
Sender:	cygwin-owner AT cygwin DOT com
Mail-Followup-To:	cygwin AT cygwin DOT com
Delivered-To:	mailing list cygwin AT cygwin DOT com

At 06:46 AM 12/17/2010, Ross Hemingway wrote:
>Hi,
>I have installed cygwin and Exim into 3 different Server 2008R2 
>(64bit).  I'd like to report the following errors that are 
>consistent through out.  This applies to all version of 1.7.x so far.
>
>1/ Exim install script does not complete through the regular 
>setup.exe system.  The script never gets its .done file extension, 
>so it pops up an error "did not complete", but it does seem to have 
>completed its install task regardless.
>
>2/ Exim will not run error free, until you do a "rebaseall" on the 
>installed cygwin.  The errors are seen when it tries to do a 
>mailing, and it creates a lot of "permissions access 
>errors".  Rebasing the system fixes it.
>
>3/  rebaseall script has a fault on line 91, where   if [ ! -w 
>"$TmpDir" ].    This always returns an error, despite the file 
>location being OK and writable.  It's probably a permission issue 
>again.  If we comment out this code part, the script does its job OK.
>
>4/  inetd.exe:  This is not an error, but a big inconvenience.  When 
>this inetd is installed as a service (cygrunsrv -I), and then 
>started as a service (net start inetd), it does not keep a 
>Services.msc presence. Hence you cannot stop it (net stop 
>inetd).  The only way to stop it is with a force kill process on the inetd.exe.

Thanks for the report about exim. The need to rebaseall on many 
systems has already
been mentioned several times. I will make sure that this is clear in 
the documentation
and perhaps add a warning in exim-config.
About the postinstall, it's the first time this problem is reported. 
Has setup changed its
criterion to add the "done" extension ? It is normal for the last 
command in the script
to fail.

Pierre


--
Problem reports:       http://cygwin.com/problems.html
FAQ:                   http://cygwin.com/faq/
Documentation:         http://cygwin.com/docs.html
Unsubscribe info:      http://cygwin.com/ml/#unsubscribe-simple

- Raw text -