Mailing-List:	contact cygwin-help AT cygwin DOT com; run by ezmlm
List-Subscribe:	<mailto:cygwin-subscribe AT cygwin DOT com>
List-Archive:	<http://sourceware.org/ml/cygwin/>
List-Post:	<mailto:cygwin AT cygwin DOT com>
List-Help:	<mailto:cygwin-help AT cygwin DOT com>, <http://sourceware.org/ml/#faqs>
Sender:	cygwin-owner AT cygwin DOT com
Mail-Followup-To:	cygwin AT cygwin DOT com
Delivered-To:	mailing list cygwin AT cygwin DOT com
X-BigFish:	VP
Date:	Thu, 16 Dec 2004 14:05:12 -0700
From:	Isaac Foraker <isaac DOT foraker AT xilinx DOT com>
Subject:	Re: find command hangs for 20 sec before starting with cygwin1.dll is 1.5.12
In-reply-to:	<20041215202025.29944.qmail@web52802.mail.yahoo.com>
To:	cygwin AT cygwin DOT com
Message-id:	<41C1F888.7050501@xilinx.com>
Organization:	Xilinx, Inc.
MIME-version:	1.0
User-Agent:	Mozilla Thunderbird 1.0 (Windows/20041206)
References:	<20041215202025 DOT 29944 DOT qmail AT web52802 DOT mail DOT yahoo DOT com>
X-IsSubscribed:	yes
X-MIME-Autoconverted:	from quoted-printable to 8bit by delorie.com id iBGL5PJd027447

I am experiencing the same delay with findutils 4.2.10-5. If I downgrade 
to an older version of findutils, the delay goes away. On my system, 
`find' was taking 30-40 seconds to start. I found that after I removed a 
bad mapped network drive, the delay dropped to 6-7 seconds for `find' to 
start. I am also finding that running `mount' to display the list of 
mounts pauses for the same 6-7 seconds, and if I run `mount' and `find' 
at the same time, they both always finish at the same time, even if I 
start running them a couple seconds apart. That is about the extent of 
diagnostic I have time to do right now.

IF

Andrew Stebakov wrote:

>Hi,
>
>I just updated my cygwin to latest (version 1.59) and
>cygwin1.dll is 1.5.12.
>I found that “find” command takes a long time to start
>(about 20 seconds). It shows in my xemacs when I load
>ecb and issue igrep-find. 
>I replaced the cygwin1.dll with some old version and
>the problem went away (also I had to replace xargs,
>grep and find executables for the old ones). 
>
>On another PC the same cygwin with xemacs doesn’t show
>the problem.
>Both of them have the VirusScan on. I tried to disable
>the VirusScan but it doesn’t fix the problem.
>What can I do fix it? Can I get the previous version
>of cygwin1.dll?
>
>Thanks in advance,
>Andrei
>

--
Unsubscribe info:      http://cygwin.com/ml/#unsubscribe-simple
Problem reports:       http://cygwin.com/problems.html
Documentation:         http://cygwin.com/docs.html
FAQ:                   http://cygwin.com/faq/

- Raw text -