Mailing-List:	contact cygwin-help AT sourceware DOT cygnus DOT com; run by ezmlm
List-Subscribe:	<mailto:cygwin-subscribe AT sourceware DOT cygnus DOT com>
List-Archive:	<http://sourceware.cygnus.com/ml/cygwin/>
List-Post:	<mailto:cygwin AT sourceware DOT cygnus DOT com>
List-Help:	<mailto:cygwin-help AT sourceware DOT cygnus DOT com>, <http://sourceware.cygnus.com/ml/#faqs>
Sender:	cygwin-owner AT sourceware DOT cygnus DOT com
Delivered-To:	mailing list cygwin AT sourceware DOT cygnus DOT com
From:	Michael Ring <Michael DOT Ring AT T-Mobil DOT de>
To:	cygwin AT sourceware DOT cygnus DOT com
Subject:	Re: Using glib(c) and gtk+ in Cygwin
Date:	Wed, 28 Jun 2000 10:20:30 +0200
Message-ID:	<7tcjlsoivqut0soaogkgv67l2pp2ktlm0o@4ax.com>
References:	<Re: Using gli...( DDA:RFC-822=cygwin-owner AT sourceware DOT cygnus DOT com; O=mb400; OU1=smtp-gwy; P=dtm; A=viat; C=de )>
In-Reply-To:	<Re: Using gli...( DDA:RFC-822=cygwin-owner@sourceware.cygnus.com; O=mb400; OU1=smtp-gwy; P=dtm; A=viat; C=de )>
X-Mailer:	Forte Agent 1.8/32.548
MIME-Version:	1.0
X-MIME-Autoconverted:	from quoted-printable to 8bit by delorie.com id EAA02125

See the attached spec-files for rpm ; I built glib & gtk 1.2.8 without
any trouble with those; Simply execute the commands in the %build
section to build and the use the commands in the %install section to
install;

Hint:

%configure is a macro and expands to :

libtoolize --copy --force

./configure --prefix=/usr i686-pc-cygwin


Hope that helps


Michael Ring

--
Want to unsubscribe from this list?
Send a message to cygwin-unsubscribe AT sourceware DOT cygnus DOT com

- Raw text -