Mail Archives: cygwin/1998/03/06/02:21:02
okey. Here is my tip for installing b19.
make sure you have environment variable TEMP points to c:\tmp and TMP
points to c:\tmp. Also use the c:\tmp as the default unpack directory.
Good luck!
---
Harry L. Chen
hchen4 AT cs DOT umbc DOT edu
Laboratory for Advanced Information Technology
University Of Maryland Baltimore County
Public PGP Key: http://www.cs.umbc.edu/~hchen4/pub/pgp
On Fri, 27 Feb 1998, Bryan T. Schmersal wrote:
> At 01:15 PM 2/27/98 +0100, Utilisateur genesis wrote:
> >When I install this package, unpacking put files in /tmp directory, but
> when setup start, it fails with error "Setup is unable to find installation
> languages in C:\TMP\SETUP.LID file. Error 105".
> >
> >Do you have any suggestion about this problem ???
>
> I had the same problem. Does C:\TMP exist? The setup program says that it
> will create it
> if it doesn't but after I got the same error you did, all I had in C:\ was
> a *file* named
> tmp. After I removed the file tmp and created the dir tmp, setup ran
> fine...
> -------------------------------------------------------
> Bryan T. Schmersal Transarc Corporation
> Senior Member of Technical Staff 707 Grant Street
> bryans AT transarc DOT com Pittsburgh, PA 15219
> http://www.transarc.com/~bryans (412)338-4351
> -------------------------------------------------------
>
>
> -
> For help on using this list (especially unsubscribing), send a message to
> "gnu-win32-request AT cygnus DOT com" with one line of text: "help".
>
-
For help on using this list (especially unsubscribing), send a message to
"gnu-win32-request AT cygnus DOT com" with one line of text: "help".
- Raw text -