X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient: geda-user AT delorie DOT com
Content-Type: text/plain; charset=us-ascii
Mime-Version: 1.0 (Apple Message framework v1085)
Subject: Re: [geda-user] geda-skeleton-project: Lowering the cost of a starting a gEDA project
From: John Doty <jpd AT noqsi DOT com>
In-Reply-To: <87wqvhd4tw.fsf@gmail.com>
Date: Sun, 13 Jan 2013 09:02:51 -0700
Message-Id: <859D19F5-2072-408E-9632-324C2C943163@noqsi.com>
References: <87wqvhd4tw DOT fsf AT gmail DOT com>
To: geda-user AT delorie DOT com
X-Mailer: Apple Mail (2.1085)
Content-Transfer-Encoding: 8bit
X-MIME-Autoconverted: from quoted-printable to 8bit by delorie.com id r0DG2v4M001038
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com
Precedence: bulk


On Jan 12, 2013, at 10:34 PM, Ben Gamari wrote:

>  * a script to automate the initial configuration of the project
>  * a Makefile for performing some common tasks (e.g. generating
>    tragesym symbols, updating the pcb layout, and exporting gerbers)
>  * some documentation describing use of the initialization script and
>    Makefile
>  * further discussion to clarify a few common questions about the
>    toolchain

Since this is pcb-centric rather than geda-centric, I think it would be better to call it "pcb-skeleton-project".

John Doty              Noqsi Aerospace, Ltd.
http://www.noqsi.com/
jpd AT noqsi DOT com