X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
Date: Fri, 30 Aug 2013 13:41:37 -0400
Message-Id: <201308301741.r7UHfbNj001647@envy.delorie.com>
From: DJ Delorie <dj AT delorie DOT com>
To: geda-user AT delorie DOT com
In-reply-to: <5220D115.2080600@sonic.net> (message from Dave Curtis on Fri, 30
	Aug 2013 10:06:29 -0700)
Subject: Re: [geda-user] gsch2pcb -- remind me how it works
References: <5220D115 DOT 2080600 AT sonic DOT net>
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com
Precedence: bulk


Perhaps the key is the 'a' suffix - lower case letters on the ends of
refdes's are treated differently between the various tools, so you
should avoid them.  Slotted components should have the *same* refdes.

Assigning a footprint to each slot is OK as long as they're the same.
If they're different, it's undefined which one "wins".