X-Authentication-Warning: delorie.com: mail set sender to geda-help-bounces using -f X-Recipient: geda-help AT delorie DOT com DKIM-Signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=gmail.com; s=gamma; h=mime-version:sender:in-reply-to:references:date :x-google-sender-auth:message-id:subject:from:to:content-type; bh=xllS6F8AKRHrbgq4KAp2MTjpPf7LjQL5hazTWHuO7n8=; b=cR8B9LL8gXyF2nW4pGw2GnwtOqYanAzvA3aEk57pRj90gdxSLUfYW/vzNpIWlGhu81 DnJy1DqtToZWiYMlzbHvhy7A6ujbwWHFiQjhU1ySyFf2Xw7i8SmuOjxR2lte097Druq9 MlXHDXltMzeLbywvH0zIdKMBVIfWKQ3Ft3/R8= MIME-Version: 1.0 Sender: krahabors AT gmail DOT com In-Reply-To: <20120103183239.29130.qmail@stuge.se> References: <201201031452 DOT q03EqBXC028986 AT envy DOT delorie DOT com> <201201031548 DOT q03FmaQj031068 AT envy DOT delorie DOT com> <201201031606 DOT q03G6Nr7031765 AT envy DOT delorie DOT com> <201201031635 DOT q03GZ6as032699 AT envy DOT delorie DOT com> <20120103183239 DOT 29130 DOT qmail AT stuge DOT se> Date: Wed, 4 Jan 2012 15:32:15 +0200 X-Google-Sender-Auth: VHb-GjUFX3rtW4JGC1oPczLIxuQ Message-ID: Subject: Re: [geda-help] Footprints From: KPL To: geda-help AT delorie DOT com Content-Type: text/plain; charset=ISO-8859-1 Reply-To: geda-help AT delorie DOT com Errors-To: nobody AT delorie DOT com X-Mailing-List: geda-help AT delorie DOT com X-Unsubscribes-To: listserv AT delorie DOT com Precedence: bulk I was trying this a few times before, but did not find at a time if it was possible to add a rat net directly in PCB program, without netlist? That would help a lot to avoid mistakes. > > I sometimes draw the PCB directly, without first using gschem, if > I've already built a prototype and the circuit is not too big, or > if I am in a really big hurry. -- KPL