X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
Date:	Thu, 7 Feb 2019 12:18:56 -0800
From:	Erturk Kocalar <erturkk AT kocalar DOT com>
To:	geda-user AT delorie DOT com, geda-user AT delorie DOT com
Subject:	[geda-user] PCB symbol with just silkscreen
Message-ID:	<20190207121856.0be3ce9a@pitop51>
X-Mailer:	Claws Mail 3.14.1 (GTK+ 2.24.31; arm-unknown-linux-gnueabihf)
MIME-Version:	1.0
Reply-To:	geda-user AT delorie DOT com

Hi there,

I want to put the open-source hardware logo on silkscreen on my first
gEDA project but could not figure out how to do it. Is there a quick
tutorial on pasting images or how buffers work?

I tried two ways:

1) copy/paste silkscreen between two pcb files:

Downloaded a pcb with oshw symbols from here:
https://www.evilmadscientist.com/2011/the-open-source-hardware-logo/

I can make an element out of a selected symbol, but how do I save it to
a file and then paste it into the silkscreen layer of my design file?

2) Better, I tried to make a pcb symbol from a logo. However,
Pcb won't save the element from buffer unless it has a via or pin.

To make matters worst :), I'm using a raspberry pi 3b to design my
project :), so the pcb version is older (20140316).

Thank you very much,
Erturk Kocalar

- Raw text -