X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
Date:	Tue, 21 Jul 2015 22:47:40 -0400
Message-Id:	<201507220247.t6M2leS2006081@envy.delorie.com>
From:	DJ Delorie <dj AT delorie DOT com>
To:	geda-user AT delorie DOT com
In-reply-to:	<1507220238.AA03807@ivan.Harhan.ORG> (falcon@ivan.Harhan.ORG)
Subject:	Re: [geda-user] [OT] I need help with selecting components
References:	<1507220238 DOT AA03807 AT ivan DOT Harhan DOT ORG>
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

> But what about the polarity?

I think I use a hacked 0603 footprint for mine, which has a polarity
indicator, but I usually end up looking at the schematics to determine
which way to put LEDs on.  Even then, it's hard to figure out which
pin is which on the LED itself.  However, that's the type of LED eval
boards use.

> Is it the same as what you had in mind?  TI used the 3-pin version,
> with the middle pin unused.

Weidmuller makes a wide range of connectors, I use these:

http://www.delorie.com/house/furnace/furnace-blinky.jpg

- Raw text -