delorie.com/archives/browse.cgi   search  
Mail Archives: geda-user/2014/02/27/15:57:30

X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient: geda-user AT delorie DOT com
Message-ID: <530FA6A2.9030209@estechnical.co.uk>
Date: Thu, 27 Feb 2014 20:57:06 +0000
From: Ed Simmons <ed AT estechnical DOT co DOT uk>
User-Agent: Mozilla/5.0 (X11; Linux x86_64; rv:24.0) Gecko/20100101 Thunderbird/24.3.0
MIME-Version: 1.0
To: geda-user AT delorie DOT com
Subject: Re: [geda-user] Via under a pad?
References: <CALSZ9gohqcqTT7y8x8x2wZdrcv8s2M-DhaN8vB5Zf6uvpRrCYA AT mail DOT gmail DOT com>
In-Reply-To: <CALSZ9gohqcqTT7y8x8x2wZdrcv8s2M-DhaN8vB5Zf6uvpRrCYA@mail.gmail.com>
X-Authenticated-As: ed AT estechnical DOT co DOT uk
X-Extend-Src: mailout
Reply-To: geda-user AT delorie DOT com

Hi Rob,
On 27/02/14 20:01, Rob Butts wrote:
> Is it bad practice to put vias under pads?  These pads are twice as 
> big as the vias.
>
> Just curious.
Can you afford the via being much smaller? We put vias 'in pad' but make 
sure they're really small so they don't suck up away the solder.

Typically, I tend to try and place vias next to the pad unless 
absolutely necessary.

On the other hand, for heat sinking with the PCB, we use an array of the 
smallest vias our fab house will drill (0.2mm hole) under the large heat 
sink pad of SMT mosfets or transistors, with a large copper fill on as 
many layers as possible to dissipate the heat.

It depends on what you're doing as to which approach is right. ;-)

Hope that helps!
Ed

- Raw text -


  webmaster     delorie software   privacy  
  Copyright © 2019   by DJ Delorie     Updated Jul 2019