delorie.com/archives/browse.cgi   search  
Mail Archives: geda-user/2013/09/18/13:25:06

X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
Date: Wed, 18 Sep 2013 13:24:58 -0400
Message-Id: <201309181724.r8IHOwHP007496@envy.delorie.com>
From: DJ Delorie <dj AT delorie DOT com>
To: geda-user AT delorie DOT com
In-reply-to: <1379488984-sup-7784@dennou> (message from Kevin Redon on Wed, 18
Sep 2013 09:27:33 +0200)
Subject: Re: [geda-user] square clearance
References: <1379435002-sup-1363 AT dennou> <201309171649 DOT r8HGn174009713 AT envy DOT delorie DOT com> <1379488984-sup-7784 AT dennou>
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com

> Aren't square clearances manufacturable?

http://www.delorie.com/pcb/notches.html

In general, sharp corners, inside or outside, are less preferred than
rounded transitions, manufacturability-wise.

- Raw text -


  webmaster     delorie software   privacy  
  Copyright © 2019   by DJ Delorie     Updated Jul 2019