delorie.com/archives/browse.cgi | search |
X-Authentication-Warning: | delorie.com: mail set sender to geda-user-bounces using -f |
Date: | Fri, 26 Jul 2013 13:42:42 -0400 |
Message-Id: | <201307261742.r6QHggBi028047@envy.delorie.com> |
From: | DJ Delorie <dj AT delorie DOT com> |
To: | geda-user AT delorie DOT com |
In-reply-to: | |
<CALSZ9goNMNNeKOyO2E3+bM99i2n6+i2BuS64Fz2ykmzNNC=xQQ AT mail DOT gmail DOT com> | |
(message from Rob Butts on Fri, 26 Jul 2013 13:24:14 -0400) | |
Subject: | Re: [geda-user] PCB doesn't auto-route |
References: | <CALSZ9goWyDGyQd-gmAxWk6d30XKSVjavEQYa3FrWSOB7u7LD9g AT mail DOT gmail DOT com> |
<201307261708 DOT r6QH8BdA026224 AT envy DOT delorie DOT com> <CALSZ9goNMNNeKOyO2E3+bM99i2n6+i2BuS64Fz2ykmzNNC=xQQ AT mail DOT gmail DOT com> | |
Reply-To: | geda-user AT delorie DOT com |
Typically that means you need to press the 'o' key but sometimes that means you need to manually put in thermals for power/ground connections to a polygon.
webmaster | delorie software privacy |
Copyright © 2019 by DJ Delorie | Updated Jul 2019 |