X-Authentication-Warning:	delorie.com: mail set sender to geda-help-bounces using -f
X-Authentication-Warning:	envy.delorie.com: dj set sender to dj AT delorie DOT com using -f
From:	DJ Delorie <dj AT delorie DOT com>
To:	geda-help AT delorie DOT com
Subject:	Re: [geda-help] PCB: bottom layer split
In-Reply-To:	<alpine.LFD.2.20.1901131708510.24356@kai.zorinco.com> (geda-help@delorie.com)
Date:	Sun, 13 Jan 2019 20:20:36 -0500
Message-ID:	<xnmuo4dogr.fsf@envy.delorie.com>
MIME-Version:	1.0
Reply-To:	geda-help AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-help AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

"Christopher Nielsen (chris AT zorinco DOT com) [via geda-help AT delorie DOT com]"
<geda-help AT delorie DOT com> writes:
> But this is not saved? If I save the pcb and open again then  file->export 
> gerbers, it's back to the bottom layer missing the traces (on a different 
> board)...

It definitely should be saved. There'll be a line in your *.pcb like
this:

Groups("1,c:2:3:4:5:6,s:7:8")

You can manually edit the *.pcb in case it's corrupted that line in a
way that it doesn't save it right, but I don't recall that ever
happening.

- Raw text -