delorie.com/archives/browse.cgi   search  
Mail Archives: geda-help/2014/10/09/05:12:55

X-Authentication-Warning: delorie.com: mail set sender to geda-help-bounces using -f
X-Recipient: geda-help AT delorie DOT com
Message-ID: <20141009091237.5539.qmail@stuge.se>
Date: Thu, 9 Oct 2014 11:12:37 +0200
From: Peter Stuge <peter AT stuge DOT se>
To: geda-help AT delorie DOT com
Subject: Re: [geda-help] Panelizing howto or examples?
Mail-Followup-To: geda-help AT delorie DOT com
References: <1412784061 DOT 2815 DOT 98 DOT camel AT linetec> <685015500 DOT 1106923 DOT 1412786931337 DOT JavaMail DOT yahoo AT jws10651 DOT mail DOT bf1 DOT yahoo DOT com> <1412843798 DOT 2815 DOT 127 DOT camel AT linetec>
MIME-Version: 1.0
In-Reply-To: <1412843798.2815.127.camel@linetec>
Reply-To: geda-help AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-help AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com

Richard Rasker wrote:
> OK, so basically you indicate the cut lines of the individual boards on
> the silk layer,

The router path should probably be on a separate layer, so that your
board vendor doesn't have to separate it from the silk print manually.

> with the outline layer defining the overall panel edge.

Right.


//Peter

- Raw text -


  webmaster     delorie software   privacy  
  Copyright © 2019   by DJ Delorie     Updated Jul 2019